⚠️ Status: Obsolete
The Mircom FA-200 is a legacy fire alarm panel. Replacement boards are no longer manufactured. A full system upgrade is highly recommended.
Common Mircom FA-200 Trouble Codes
- ZONE TROUBLE: A conventional initiating zone has an open circuit or a missing end of line resistor which prevents the panel from properly monitoring the detectors.
- SIGNAL FAULT: The notification appliance circuit has a wiring break or short that will prevent the horns and strobes from sounding during an emergency.
- BATTERY FAULT: The backup power supply batteries have fallen below the required standby voltage or are completely disconnected from the main board.
- GROUND FAULT: A bare field wire on either a zone loop or notification circuit has made physical contact with a grounded backbox or metal conduit.
Is your legacy Mircom FA-200 panel displaying constant zone faults in your Austin retail shop or small office? Our licensed technicians can troubleshoot these conventional wiring issues and provide a clear path to upgrade your obsolete hardware to ensure full code compliance.